Fresh Water Tank for VW T7 & Ford Transit Custom 2024 Onwards - D.I.Y. installation kit for camper conversions (CAK-239F)

FITTING INSTRUCTIONS 

Centrally fitted fresh water tank positioned down the middle of the vehicle between the fuel tank and the exhaust heat shielding.  The rear of the tank sits just in front of the rear suspension arm cross member on an L1 and one section forward of this on an L2.  (There is space on an L2 for an additional tank behind).  It is positioned against wiring harness retaining strap stud on the exhaust side to leave minimal clearance from fuel tank.  The front face of the tank is level with the Adblu tank, which leaves a large amount of space in front of the tank to fit heaters, etc.

Adjacent to the exhaust heat shielding is a wire harness in a ‘J’ bracket that is clipped to cross member.  The ‘J’ wiring harness support bracket needs twisting slightly away to clear the tank.

This wiring may need to be unclipped from the cross member and cable tied to an adjacent hole nearer to heat shielding to allow tank to centre if this is pushing it too close to the fuel tank.

2 identical brackets used.  Currently steel but will be galvanised shortly.

Rear bracket requires 2 x 4” hookbolts.  These both hook into the front lip of the ‘J’ shaped cross member. 

Front brackets require 2 x 4” hookbolts that need 9/10mm holes drilled both sides on rear face of cross member.

Connections are to rear offside face of tank.  All variations available, eg pressure fill, gravity fill or waste.

KIT CONTAINS:-

- 1x CAK-190 Water Tank with Fresh Fittings

- 1x Holding Brackets

- 1x Set of Hook Bolts for Brackets

- 1x 40mm Filler Neck Locking Cap + 2 Keys  (COLOUR IN DROP DOWN BOX)

- 1x 1.5M Length of Blue 40mm Filler Pipe

- 2x 40mm Hose Clips

- 1x Remote Drain Tap Kit (BLUE)

OPTIONAL CONTENTS:-

- 1x Fresh & Waste Water Level Gauge with Read out Panel (MTT/G)

- 1x Level Sensor to Suit CBE Control Panel Kits (SPE/100)