CAK-238F078WKIT Fresh & Waste Water Tank Kits For VW Crafter 2017 Onwards & MAN TGE MWB D.I.Y. Installation Kit Van to Campervan

KIT CONTAINS:-

- 1x CAK-238 - 75 Litre Water Tank with Fresh Fittings 

- 1x CAK-078 - 50 Litre Water Tank with Waste Fittings

- 2x Sets Holding Brackets

- 2x Sets of Hook Bolts for Brackets

- 1x 40mm Filler Neck Locking Cap + 2 Keys (Choose Colour From Drop Down)

- 1x 2M Length of Blue 40mm Filler Pipe

- 2x 40mm Hose Clips

- 1x Remote Drain Tap Kit (BLUE)

- 1x Remote Drain Tap Kit (GREY)

FITTING DETAILS

The fresh tank is designed to fit along the driver’s side sill behind the driver’s door. Three fittings are pre-welded, two onto the rear face of the tank: 1 x 15mm pump outlet chassis side and 1 x 25mm drain sill side.  The 40mm inlet is pre-welded onto the chassis side face of the tank at the rear, fitted low to miss the main chassis member. Fixing kit supplied with 3 x galvanised brackets, 3 x 5 inch hookbolts and 3 x 6 inch hookbolts all with locking nuts. The sill side of the brackets require the 6 inch hookbolts and the chassis side of the brackets require the 5 inch hookbolts. All sill side 6” hookbolts hook into pre-existing sill bungs.  Remove bung, hook in, then replace bung with small notch cut to allow for hookbolt. All chassis side 5” hookbolts hook into pre existing holes in the base of the chassis.

The waste tank is designed to fit longitudinally on the passenger side behind the fuel tank in front of the rear axle. Front bracket hooks one side into chassis side of cross member using 8 inch hookbolt. The handbrake side of the bracket hooks into existing hole in crossmember for handbrake cable using a 4 inch hookbolt. Rear bracket will need 2 holes drilled into front face of cross member just in front of rear axle using 2 x 7 inch hookbolts. Please note: that the tank will need to be packed on the rear between tank and cross member with a 15mm pack on the hump of the tank.  A block will be needed to the side of the hump of approximately 65mm.  Packing is also needed on the front of the tank between the tank and the cross member of approximately 20mm to clear the brake pipe.  Difference in packing height is to maintain slope of tank so it slopes slightly to the front for draining. 2 x 3/4 inch waste inlet fittings pre-welded to front face of tank on left hand side (to miss fuel tank).

OPTIONAL CONTENTS:-

- 1x Combined Fresh & Waste Water Level Gauge with Read out Panel (MT214/G)